Gorgy Timing LEDI Network IN - 2. Full Setup; 2.1. Network Configuration; 2.1.1. Default Configuration

To Next Page

To Previous Page

MDE-LEDI-NETWORK-IN-4065V1.0

2. FULL SETUP

This part contains information for a full conguration of the product. It should be

used for ne network conguration and output cards set-up

2.1. NETWORK CONFIGURATION

2.1.1. Default conguration

The LEDI Network IN is congured to automatically take an IP address from a DHCP

server. At startup, the product broadcast a DHCP query to get an IP address. This query

contains a DHCP name. There are two cases:

If a DHCP server is installed on the network, it record the DHCP name and return an ►

IP address. The LEDI Network IN starts working with this address.

If no DHCP server is installed, the LEDI Network IN automatically uses a default IP ►

address in the range 169.254.x.y (where x and y are between 0 and 255).

The default DHCP identier of the product is CRnnnnnn with nnnnnn, the serial number

on 6 digits. The serial number is written on the identication stamp on the top or on the

bottom of the product.

The default SNMP name of the product (that can be seen from a SNMP browser (see

part 6) or from a WEB browser) is LediNetwkINnnnnnn with nnnnnn, the serial number

on 6 digits.

2.1.2. Changing network parameters

Use the GTNetMng tool provided on the CDROM to congure your device:

Insert the CDROM in the drive. Start the GTNetMng tool that is localized in the ►

directory Common\Conguration

4/ For example, if your CD reader has letter E:, the GTNetMng tool is localized in E:\Common\Conguration\

GTNetMng.exe

ENGLISH