Gorgy Timing LEDI Network IN

To Next Page

To Previous Page

MDE-LEDI-NETWORK-IN-4065V1.0

IP address ►

Indicate the network address affected to the device. An IP address is made of four

numbers separated by a dot. Each number range from 0 to 255;

DHCP identier ►

Identier to be used when the LEDI Network IN is congured in DHCP mode. This

identier has 8 letters maximum. The default value is CRnnnnnn (where nnnnnn is

the serial number on 6 digits);

Network submask ►

Indicate the width of the network you use. For example, a network submask

255.255.255.0 indicates that only the last number change (in the example above,

address in the network can change between 192.168.10.1 to 192.168.10.254)

Gateway address ►

If you want the LEDI Network IN to communicate with devices outside the local

network, you must indicate a gateway that will be used to go outside local network;

Without gateway ►

Check this box when you don’t have a gateway on your network (or don’t want to

use it);

PRODUCT INFORMATION

Here is a description of the product information area:

Hardware ►  GT serial number

Display the Gorgy Timing serial number of the product. This is a 6 digits number

which is the same than the one stamped on the bottom or background of the rack

Hardware ►  Product code

Display the Gorgy Timing base code of the product without option (9257 for a LEDI

Network IN)

Ethernet Interface ►  (MAC) Address

Indicate the Medium Access address of the Ethernet interface of the LEDI Network IN

Ethernet Interface ►  Adapter Serial number

Indicate the serial number of the Ethernet interface of the LEDI Network IN. This

information can be useful for maintenance;

Firmware ►  Description

Short text that describes which software is running on your product

7/ If you congure several devices to communicate on the same network, you must have the same network submask.

4. WEB INTERFACE

Gorgy Timing LEDI Network IN - Page 70