a. Type in your new Admin Password in New Password field.
b. Type in again same entered password in Confirm Password field.
5. Press Save and Apply to save your new setting.
Figure 13: Admin Level Password
Note: DO NOT USE same password for both user and admin accounts.
Changing HTTP / HTTPS Web Access Port
1. Access the Web GUI of your DP750 using the admin’s username and password. (Default username
and password is: admin/admin).
2. Press Login to access your settings.
3. Go to Maintenance Security Settings Web/SSH.
4. In Web/SSH Settings page, locate HTTP / HTTPS Web Port field and change it to your
desired/new HTTP / HTTPS port.
Note: By default, the HTTP port is 80 and HTTPS is 443.
5. Select the Web Access Mode depending on desired protocol (HTTP or HTTPS).
6. Press Save and Apply to save your new setting.
Note: A reboot is required for this change to take effect.