27
Using the gauge as a reference, adjust the screw
positions in the direction of the arrow to correct
skew.
Only micro movements are required. Test between
each adjustment until the skew is corrected.
5.4.4 Outfeed Tray Setting
The PT 331SCC ships with two long paper guide stops and one
smaller back stop. For straight crease jobs or larger finished output,
place the guides slightly wider than the finish product and line up
the back stop with the ends of the paper guide stops.
For business card jobs, place the business card
catchers against the exit of the PT 331SCC, in line
with the output.
To Next Page
Loading...
