3
Chapter 1 Introduction
1.1 Preface
This manual only applies to the PT 331SCC. This manual contains information regarding machine safety and use.
Please keep the manual on hand for easy access when required. Do not operate the Graphic Whizard PT 331SCC
until you read and understand the instructions in this manual. Any questions regarding this machine, please contact
Graphic Whizard.
Graphic Whizard pursues a policy of continuing improvement in design and performance of the product.
Therefore, the product design and specifications are subject to change without notice.
1.2 Safety
• Please shut down and disconnect the power to the machine before performing maintenance. Make note
of connections before disconnecting. Ensure all cables are properly secured to the board.
• Read this entire manual before running the machine.
• Ensure all accessories are installed properly before running the machine.
• Ensure the power input and ground are correct before powering on the PT 331SCC. This machine runs on
110 volts
• Ensure all safety covers are in place. Do not run the PT 331SCC without the covers installed. The top cover
has an interlock switch that will stop the machine if open or removed.
• For personal safety, disconnect power before cleaning the interior of the machine.
• The blade edges are very sharp. Use caution whenever accessing the interior of the unit.
• Disconnect the power cord if the machine will not be used for an extended period.
• Install the PT 331SCC on a level surface.
• Never operate the unit with wet hands or connect or disconnect the power cord when wet or when
standing in water.
• Keep hair and clothing away from the unit.
• Keep hands clear of the unit when operating. Keep liquids away from the PT 331SCC.
• Do not place any heavy material on the machine.
• To avoid risk of shock or fire, keep metal and flammable materials out of the machine. If the unit is
exposed to shock or fire and if it is safe to do so, power off and unplug the unit then call a service
technician. Do not power on the unit without consulting a service technician.
• If the machine overheats or if you detect an odor or see smoke, immediately shut down the unit and
contact your local service technician.
Power Supply
• The AC input voltage frequency is AC110/50-60Hz. Please use a power cord rated for 10A or higher.
• If the voltage or frequency is not within range, the machine may fail to function.
• Do not remove the power cord while machine is in use. Power down the PT 331SCC before disconnecting
the power cord.
• Ensure the unit is connected to a properly grounded outlet before powering on.
To Next Page
Loading...