41
6.1.2 Error
E-1 Crease Motor Error
A Crease Motor Error indicates the PT 331SCC has encountered an error with
the crease motor. The crease motor error is a hard fault. The machine will not
run until this error has been resolved.
• Power off and on the SCC to reset the machine. Any paper caught in the SCC will be cut when the cut motor
test runs on power up.
• Press the paper advance button to move the paper though the crease section. If the paper is sticking out
of the machine exit, try pulling the paper while pressing the paper advance button to assist in paper
extraction.
• Press the advance button until all paper has been cleared.
• Check the crease job depth. If too heavy, adjust the crease depth. Ensure the paper is within machine specs.
• Remove the crease tools and check for paper that may be caught in the crease section. Clear any scraps.
• If the error appeared on power on, try powering on the unit again.
• If the error persists and no paper is found in and around the crease section, contact your local GW dealer
for service.
• Run several crease tests to ensure the unit is functioning.
E-2 Cut Motor Error
A Cut Motor Error indicates the PT 331SCC has encountered an error with the
cut motor and is a hard fault.
• Power on and off the SCC to reset the machine. Any paper caught in the SCC will be cut if the restart
successfully cleared the fault. Press the advance button to clear any remaining paper.
• Check for paper scraps around the knife assembly. Clear any scraps. Empty the waste bin.
• If the SCC continues to present the error after a restart, contact your local GW dealer for service.
To Next Page
Loading...
