12
Software Version & Serial Number
When calling Graphic Whizard for warranty replacement or troubleshooting, you must provide the Graphic
Wizard serial number, located on the machine near the power on button. It may also be necessary to provide the
manufacturer serial number and software version. Please have the Graphic Whizard machine serial number,
software version, total cut and crease count, and the totals count available.
5.3.3 Mode Introduction
To view the available programming options and to input data, press the Mode button. Pressing the Stop Key
will return you to the Ready screen if you have not made any changes.
The following is a list of available options:
Recall Job
The PT 331SCC can save a total of 20 jobs. Each job is saved under a number
(starting at 1). To recall a job, key in the number that corresponds to the
required job on the number pad and press the enter button.
Factory Template
The PT 331SCC comes preloaded with preset templates. The template parameters are as follows:
• 3.5” x 2”
• 3.5” x 5”
• 3.5” x 8“
• 5” x 8”
• 5” x 8.5”
• 5.5” x 8”
• 5.5” x 8.5”
To access the templates, press the Mode Key once to enter factory template screen. Press the Page Up Key or the
Page Down Key to scroll through the preset templates. Press the Enter Key to select the desired template. When
using the factory templates, set the slitter positioning gauge to match the width of the finished job (3.5” or 5.5”).
To Next Page
Loading...
