GRAPHTEC CE5000 SERIES - 5 List of Tools; Tools; Greasing and Gluing Points; Subparts List

CE5000-UM-251-9370 5-1
5 LIST OF TOOLS
5 LIST OF TOOLS
5.1 Tools
No. Adjustment Item Jig Tool
1 Pen force adjustment Cutter pen holder (CB09)
Correx Dial Tension gauge (50,300,500 gf)
2 Distance adjustment Glass scale
3 Pen block height adjustment 10 mm height block
4 Firmware update PC, USB I/F cable
5 X-drive belt tension adjustment Push-pull gauge (2 kg)
6 Y-drive belt tension adjustment Push-pull gauge (2 kg)
7 Replacing the main board
Short screwdriver (50 mm)
8 Replacing the vacuum fan
5.2 Greasing And Gluing Points
No. Grease or Glue Point Grease or Glue name Application quantity
1 Cam Shinetu silicon grease G501 Suitable quantity
2 X-drive motor pulley Shinetu silicon grease G501 Suitable quantity
3 Y-drive motor pulley Shinetu silicon grease G501 Suitable quantity
4 X-drive pulley Shinetu silicon grease G501 Suitable quantity
5 Y-drive pulley Shinetu silicon grease G501 Suitable quantity
6 Y-tension pulley Shinetu silicon grease G501 Suitable quantity
7 Y-rail, push roller assy sliding area Shinetu silicon grease G501 Suitable quantity
8 Y-motor drive pulley set screws Loctite 222 Small quantity
9 X-motor drive pulley set screws Loctite 222 Small quantity
10 X-drive pulley set screws Loctite 222 Small quantity
5.3 Subparts List
No. Where used Subpart name Size
1 Front guide 120 Measuring tape 250 mm x 2
2 Rear paper sensor Outdoor use cutting sheet, black 7 x 15 mm, thickness 0.08 to 0.1 mm
3 Y-relay board core Double-sided adhesive tape 10 x 20 mm
4 Y-rail Double-sided adhesive tape 10 x 15, 10 x 50 mm
5 Y-relay board Harness tiewrap About 100 x 2.5 mm, t=1.0 mm
6 Vacuum fan wiring harness Harness tiewrap About 100 x 2.5 mm, t=1.0 mm
7 Y-motor Bush 5 x 3 mm
8 Tension pulley Bush 4 x 3 mm
9 Drive roller bearing Bush 3 x 4.5 mm
10 Cam sensor bracket Bush 4 x 2, 4 x 12 mm
11 Cam sensor bracket Washer 4 mm