GRAPHTEC CE5000 SERIES - How to Replace the Drive Roller

CE5000-UM-251-9370 6-36
6 DISASSEMBLY AND REASSEMBLY
6.2.17 How to Replace the Drive Roller
How to detach the drive roller
(1) Detach the right and left side covers (see Subsection 6.1.1 and Subsection 6.1.2).
(2) Detach the front guide (see Subsection 6.1.5 or 6.1.6).
(3) Detach the rear guide (see Subsection 6.1.7).
(4) Loosen the two M3L6 binding head screws holding the X-motor.
X-drive pulley
M3L6 binding head screw
M3L4WP set screw
X-drive belt
(5) PushuptheX-motorfrominsidetheleftsideplatethenremovetheXdrivebeltfromtheX-drivepulley.
(6) LoosenthetwoM3L4WPsetscrewsholdingtheX-drivepulleyanddetachtheX-drivepulleyfromthe
drive roller.
(7) RemovethetwoM3L6bindingscrewsholdingtheX-driverollerbearingwithaange.
M3L6 binding head screw
X-drive roller bearing
(8) SlideouttheX-driverollerfromtheunit.Thereisabearingstopperangeandabushontheleftside
plate;don’tmissthosepartswhenremovingtheX-driveroller.