GRAPHTEC CE5000 SERIES - Adjusting the Offset of the Auto-Registration Mark Sensor

CE5000-UM-251-9370 7-12
7 ELECTRICAL ADJUSTMENTS
7.10 Adjusting the Offset of the Auto-Registration Mark Sensor
If you have the auto-registration mark sensor option, you must adjust the offset of the auto-registration mark
sensor.
How to set the auto-registration mark sensor option
(1) Load an A4 (Letter) or larger size sheet of paper in the plotter. The paper must have a printed target
crossmark.(Printoutthetargetsheet(seenextpage)onaprinter.)Thespecicationofthecrossmark
is 30 mm line length, and 0.3 to 0.5 mm line width.
(2) Mount a water-based ballpoint pen in the plotter.
(3) Turn on the power while pressing the TEST and ENTER keys.
(4) Select the media mode.
(5) Set the plotting conditions to the following settings:
Force: 12, Speed: 40, Quality: 1, Tool: Pen
(6) Press the PAUSE key to display the menu shown below.
(This menu is not displayed when the main board is new type.)
MODEL SELECT
(7) Press the NEXT key until the following menu is displayed.
MARK SENS POS
(8) Press the ENTER key to display the menu shown below.
MARK ADJ SCAN
(9) Use the Position keys to move the pen position to the printed cross mark area shown below.
Media feed
direction
10 mm
Printed target mark
Move the pen position into this area.
10 mm