GRAPHTEC CE5000 SERIES - How to Replace the Y-Flexible Cable

CE5000-UM-251-9370 6-28
6 DISASSEMBLY AND REASSEMBLY
6.2.13 How to Replace the Y-exible Cable
How to detach the Y-Flexible cable
(1) Detach the right side cover (see Subsection 6.1.1).
(2) Detach the center cover (see Subsection 6.1.3 or 6.1.4).
(3) Detach the front guide (see Subsection 6.1.5 or 6.1.6).
(4) Removethewiringharnesstie-wrapholdingtheY-exiblecableandthecoreontheY-relayboard.
(5) Detachthecoreattachedwithdouble-sidedadhesivetapetotheY-relayboard.
(6) DisconnecttheY-exiblecablefromconnectorJ501ontheY-relayboard.
(7) DisconnecttheY-exiblecablefromconnectorJ1onthemainboard.
(8) Removethefourplasticrivetsholdingtheexiblecablestopper.
Flexible cable
stopper
Y flexible cable
Plastic rivet
(9) RemovetheY-exiblecableattachedwithdouble-sidedadhesivetapetotheY-rail.