GRAPHTEC CE5000 SERIES - Page 65

CE5000-UM-251-9370 6-27
6 DISASSEMBLY AND REASSEMBLY
How to reinstall the X-motor
(1) AttachtheX-motortotheleftsideplate.
(2) Connect the X-motor cable to its connector(s) on the main board.
CE5000-40/60: ........ ConnectthecablestoconnectorJ7andJ10onthemainboard.
CE5000-120/120AP: ConnectthecablestoconnectorJ1102andJ1104ontheX-motorrelayboard.
(3) FastentheX-motorharnesswiththewiringharnesstie-wrap.
(4) HangtheX-drivebeltontheX-drivepulley.
(5) AttachtheX-motorpulleytotheX-motor.
(6) TightenthetwoM3L4WPsetscrewsholdingtheX-motorpulley.
(7) SpreadasuitablequantityofLoctite222ontheM3L4WPsetscrewholdingtheX-motorpulley.
(8) UsetheforcegaugetopulltheX-drivemotorpulleyangewitha1.2kgto1.3kgforce.
(9) Tighten the mounting screws that hold the X-motor.
(10) SpreadasuitablequantityoftheShinetusilicongreaseG501ontheX-motorpulley.
(11) MovetheX-drivepulleyandcheckthetensionoftheX-drivebelt.
(12) Reattachtheotherpartsinthereverseorderinwhichtheyweredetached.
Regarding the X-Drive belt for the CE5000-40 and -60
The X-Drive belt for the CE5000-40 and -60 were changed to the 8 mm width belt from 5 mm width belt.
WhenreplacingtheX-belt,usethe8mmwidthbeltandfollowtheprocedurebelow.
The drive belt 82TN15-5W was changed to the drive belt 82TN15-8W.
Oldpartsnumber: 378108211Drivebelt,82TN15-5W
Newpartsnumber: 378408231Drivebelt,82TN15-8W
PleasechangetheinstallingpositionoftheX-motorpulleywheninstallingthenewX-drivebelt.(Seethe
gureof“HowtoreplacetheX-drivebelt”below.)
How to replacing the X-drive belt
(1) RemovetheX-drivebeltfromtheX-drivepulleys.
(2) ChangethepositionoftheX-motorpulleyasshowninthepicturebelow.
X-motorpulley
X-motor
Changethepositionof
theX-motorpulleyto
4.5 mm from 2.0 mm.
(3) InstallthewidertypeofX-drivebelttotheX-drivepulleys.