A-2 OVER TAKE BOOST
20
Over Take Boost setting
This feature is used to boost over the SET boost setting. The kept
high boost mode that can be turned on for a set amount of time or
on constantly.
*See page 35 for operation of this feature.
1.TIME
1~99 - - - Input Over Take Boost operation time.
PS - - - - Select this feature to turn on the Over Take Boost mode
only while holding down the SHIFT button.
∞ - - - - - Select this feature to select between the SET Boost
level or Over Take Boost level with the SHIFT button.
2.DUTY RATE
This feature can adjust the rate of the boost change when the
Over Take Boost is turned on to avoid boost spike.
The higher the number, the slower the change rate gets.
(Standard setting should be 0. If boost spike occurs, increase
the duty rate)
3.AUTO / MANUAL, SET, GAIN, START BOOST
Follow the same set up procedure as the SET BOOST. see
page 18.
• Learning is required if Over Take Boost is set to a value that is
not learned yet.
• The optional Remote Switching System (sold separately) can be
used to select the SET Boost or Over Take Boost.
To Next Page
Loading...
Need help?
General
