D-8 VTEC
51
VTEC Setting
This is used to set the VTEC setting without going in to the Main Unit.
The VTEC setting with e-01 will over ride the setting on the e-
manage Unit.
1. VTEC SHIFT POINT
• Lo->Hi - - - VTEC turns on.
• Hi->Lo - - - VTEC turns off.
2. AIRFLOW ADJUSTMENT
When the VTEC shift point
is changed from factory
setting, the airflow will need
to be adjusted for proper
air/fuel ratio.
rpm:
Input range: 1500 ~ 7000rpm, 50rpm increments
Adjustment Value: %
Input range : -20 ~ +20%, 1% increments
Input range : 0 ~ 100%, 0.5% increments
To Next Page
Loading...
