Grizzly G0513 - G0513 X2 B & G0513 X2 Bf

-20-
G0513 Series Bandsaws (Mfd. Since 07/18)
Figure 14. Other bandsaw components.
D
E
F
G
G0513X2B & G0513X2BF
Shipping Inventory (Figures 13–14) Qty
A. Bandsaw (not shown) ................................. 1
B. Table ........................................................... 1
C. Miter Gauge ................................................ 1
D. Resaw Fence ............................................. 1
E. Front Rail .................................................... 1
F. Fence Assembly ......................................... 1
G. Guide Post Handwheel............................... 1
Hardware & Tools (Not Shown) Qty
• Flat Washers 8mm (Table, Fence, Rail) ..... 8
• Lock Washers 8mm (Table, Rail) ............... 5
• Hex Bolts M8-1.25 x 25 (Table) .................. 4
• Hex Bolt M8-1.25 x 90 (Positive Stop) ........ 1
• Hex Nut M8-1.25 (Positive Stop) ................ 1
• Cap Screws M6-1 x 20 (Rail) ..................... 3
• Cap Screw M8-1.25 x 20 (Rail) .................. 1
• Lock Washers 6mm (Rail) .......................... 3
• Flat Washers 6mm (Rail) ............................ 3
• Table Pin..................................................... 1
• Table Inserts ............................................... 2
• Locking Handle M8-1.25 x 44 (Fence) ....... 1
• Moving Plate (Fence).................................. 1
• Knobs M8-1.25 x 20 ................................... 2
• Rail Plates .................................................. 3
• Hex Wrench 5mm, 8mm....................1 Each
• Open End Wrench 10 x 13mm ................... 1
Figure 13. Table and miter gauge.
C
B