-24-
G0513 Series Bandsaws (Mfd. Since 07/18)
4. Loosen blade tension by rotating the quick-
release tension lever clockwise, as shown in
Figure 23.
Figure 23. Quick-release tension lever.
Tighten
Loosen
5. Adjust the upper and lower blade guides
away from the blade. Refer to Adjusting
Blade Guides beginning on Page 36 for
more details.
All saw blades are danger-
ous and may cause per-
sonal injury. To reduce the
risk of being injured, wear
leather gloves when han-
dling saw blades.
6. Remove the saw blade (refer to Blade
Changes on Page 51 for detailed instruc-
tions).
7. With the help of another person, lift the table
onto the trunnions.
Assembly
Installing Guide Post Handwheel,
Positive Stop Bolt, & Table
1. Secure the guide post handwheel onto the
handwheel shaft flat with the included set
screw (see Figure 21).
Figure 21. Guide post handwheel installed.
Guide Post
Handwheel
2. Thread the M8-1.25 hex nut halfway onto the
M8-1.25 x 90 hex bolt (this is the positive stop
bolt).
3. Thread the positive stop bolt into the thread-
ed hole on bandsaw body (see Figure 22).
Figure 22. Positive stop bolt installed.
Positive Stop
To Next Page
Loading...
Need help?
General
