-30-
G0513 Series Bandsaws (Mfd. Since 07/18)
Figure 39. Dust hose attached to bottom dust
port.
Dust Collection
To connect a dust collection hose:
1. Fit a 4" dust hose over each dust port and
secure them in place with a hose clamp (see
Figure 39).
2. Tug the hoses to make sure they do not
come off.
Note: A tight fit is necessary for proper per-
formance.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
DO NOT operate this bandsaw without an
adequate dust collection system. This saw
creates substantial amounts of wood dust
while operating. Failure to use a dust col-
lection system can result in short and long-
term respiratory illness.
To Next Page
Loading...
Need help?
General
