English (GB)
71
Setting via the operating panel
• Settings > Functions, CU 352 > Units.
Set unit standard, measuring parameter and specific unit. See the
example in fig. 130.
Fig. 130 Example of selection of units
Factory setting
The setting is done in the startup wizard and depends on the
application.
8.7.74 Date and time (4.5.3)
Fig. 131 Date and time
Description
You can set date and time as well as how they are to be shown in
the display.
The clock has a built-in rechargeable voltage supply which can
supply the clock for up to 20 days if the voltage supply to the
system is interrupted.
If the clock is without voltage for more than 20 days, it must be
set again.
Setting range
The date can be set as day, month and year. The time can be set
as a 24-hour clock showing hours and minutes.
There are three formats.
You can also select if Sunday or Monday is to be the first day of
week.
Setting via the operating panel
• Settings > Functions, CU 352 > Date and time.
1. Select and set:
• Day, Month, Year, Hours, Minutes.
2. Select format.
3. Select "Sunday" or "Monday" under "First day of week".
Factory setting
Local time.
Examples of format
2012-09-27 13:49
27-09-2012 13:49
9/27/2012 1:49 pm
If the system has been without voltage for more than
20 days since it left the factory, the clock may have
returned to the original setting: 01-01-2005 0:00.
Date and time may have been changed during the
setting of system.
There is no automatic changeover to/from daylight-
saving time.
To Next Page
Loading...
Need help?
General
