Service Manual for the Accutherm Ultra Printer 7-1
7
Disassembly
Warranty Information
The Accutherm® Ultra Printer is under warranty from the manufacturer. Prior to
performing any printer disassembly, you MUST verify that the printer is out of
warranty with your Technical Services Manager. Performing any of the steps in
this chapter may VOID warranty and is therefore PROHIBITED until advised by
Management.
Caution: The Power Supply is
the only sub-assembly approved to be
replaced in the field (FST) after warranty. All other subassemblies must
only be replaced by an RLT.
Before disassembling any part of the printer, be sure the power is
turned off. The Controller Board, the Thermal Print Head, and the
Interface Board can be damaged by static electricity. Observe ESD
precautions. Wear a grounded wrist strap and use a static mat or
other protected work surface.
To Next Page
Loading...