To Next Page

To Previous Page

GPP Series User Manual

168

Function

Program the measurement enable status register.

Description

<NRf>

8: ROF (reading overflow enable bit).

16: PTT (pulse trigger timeout enable

bit).

32: RAV (Reading available enable bit).

512: Buffer full enable bit. The register

is 16 bits. If <value> is between 512 and

1,023, it is certainly valid. If <value> is

between 1,024 and 65,535, ensure Cal

(bit8) is a valid value for it to work.

Example

:STATus:MEASurement:ENABle 8

Enables the ROF bit.

Table of Contents3
Safety Instructions6
- Safety Symbols6
- Safety Guidelines7
- Power Cord for the United Kingdom10
Overview11
- Introduction12
- Key Features15
- Front Panel17
- Rear Panel25
- Constant Voltage/Constant Current Crossover Characteristics27
Getting Started29
- Start up29
- Load Connection30
- Turning the Output On/Off31
Basic Operation33
- Display Change33
- Source Function36
Independent Output Mode41
Tracking Series and Tracking Parallel Modes42
- Load Function46
- Sequence Function50
Set Sequence Output50
Set Group Parameter52
Construct Templet54
Menu Tree57
Save and Recall59
- Delay Function62
Set Delay Output62
Set Group Parameter65
Menu Tree67
Save and Recall69
- Monitor Function71
Set Monitor72
- Recorder Function75
Set Recorder75
- Enternal I/O Control78
Key Function Description80
File Operation83
- Save/Recall83
- Restore Factory Default Settings86
System Settings87
- System Information88
- System Settings89
- Firmware Upgrading91
- Description of Using Flash Drive92
Remote Control93
- Connection Usage95
Usb97
Gpib99
Lan100
- Command Syntax106
- Command List110
Output Commands110
Measurement Instructions110
Display Functions110
Source and Load Commands111
Status Commands116
System Commands116
System Related Commands118
IEEE488.2 Common Commands118
- Command Details119
Measurement Commands119
Display Commands121
Output Commands123
Source and Load Commands126
Status Commands166
System Commands172
System Related Commands181
- SCPI Status Registers SCPI182
Event Registers184
Enable Registers184
Status Byte Register184
Standard Event Register186
Status Byte Register Commands187
Standard Event Register Commands188
Other Status Register Commands190
- Errors191
Error Message191
Command Errors191
Appendix195
- Replacing the Fuse195
- Specifications196
- Optional Accessories199
- Declaration of Conformity200

Brand	GW Instek
Model	GPP-1326
Category	Power Supply
Language	English

GW Instek GPP-1326 User Manual

Table of Contents

Questions and Answers:

GW Instek GPP-1326 Specifications

Related product manuals