Installation Manual
H3C S3600 Series Ethernet Switches Chapter 3 Installation
3-18
1) Wear an ESD-preventive wrist strap and check that it is well grounded. Take the
special stack interconnect cables out of the pack.
2) Insert the connector horizontally into the fabric port of the switch, with the front
side facing upwards.
3.5.3 Removing Special Stack Interconnect Cables
Follow these steps to remove special stack interconnect cables:
1) Wear an ESD-preventive wrist strap and check that it is well grounded.
2) Pull the clamp outwards and remove the connector from the fabric port of the
switch.
Note:
z Special stack interconnect cables are hot swappable.
z Avoid pulling the special stack interconnect cables while removing the connector.
3.6 Verifying Installation
z The correct power source is used.
z The ground wire is securely connected.
z Both of the console cable and power cord are correctly connected.
z All the interface cables are routed indoors. If there are cables outdoors, check that
the socket strip with lightning protection and lightning arresters for network ports
have been correctly connected.
To Next Page
Loading...
Need help?
General