To Next Page

To Previous Page

Installation Manual

H3C S3600 Series Ethernet Switches Chapter 4 Starting up the Switch at the Initial Boot

4-7

CPU Clock Speed : 200MHz

BUS Clock Speed : 33MHz

Memory Size : 64MB

Mac Address : 000fcb004500

Press Ctrl-B to enter Boot Menu... 5

To enter the Boot Menu, press <Ctrl+B> within five seconds after the message “Press

Ctrl-B to enter Boot Menu... 5” appears. If not, the system automatically boots and

displays:

Auto-booting...

Decompress

Image................................................................

..........................................................................

............................OK!

Starting at 0x80100000...

Initialize LSJ1LTSE........................OK!

SDRAM fast selftest........................OK!

Flash fast selftest........................OK!

CPLD selftest..............................OK!

Switch chip selftest.......................OK!

PHY selftest...............................OK!

Please check port leds...............FINISHED!

User interface aux0 is available.

Press ENTER to get started.

The appearance of “Press ENTER to get started” indicates that the switch has

completed its automatic boot.

Press <Enter>; the system displays:

<H3C>

You can configure the switch now.

H3C S3600 Series Installation Manual

Other manuals for H3C S3600 Series