H3C S5120-SI Series

1-11
Cluster Member Management
You can manually add a candidate device to a cluster, or remove a member device from a cluster.
If a member device needs to be rebooted for software upgrade or configuration update, you can
remotely reboot it through the management device.
Adding a member device
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
—
Add a candidate device to the
cluster
add-member
[ member-number ]
mac-address mac-address
[ password password ]
Required
Removing a member device
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
—
Remove a member device from
the cluster
delete-member
member-number
[ to-black-list ]
Required
Rebooting a member device
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
—
Reboot a specified member
device
reboot member
{ member-number |
mac-address mac-address }
[ eraseflash ]
Required
Configuring the Member Devices
Enabling NDP
Refer to Enabling NDP Globally and for Specific Ports.
Enabling NTDP
Refer to Enabling NTDP Globally and for Specific Ports.