1-7
z Removing a dynamic aggregate interface also removes the corresponding aggregation group. At
the same time, the member ports of the aggregation group, if any, leave the aggregation group.
z To guarantee a successful dynamic aggregation, ensure that the peer ports of the ports
aggregated at one end are also aggregated. The two ends can automatically negotiate the selected
state of the ports.
z When a load-sharing aggregation group becomes a non-load-sharing aggregation group because
of insufficient load sharing resources, one of the following problems may occur: the number of
selected ports of the actor is inconsistent with that of the partner, which may result in incorrect
traffic forwarding; the peer port of a selected port is an unselected one, which may result in
upper-layer protocol and traffic forwarding anomalies. You should fully consider the situation when
making configuration.
Configuring an Aggregate Interface
You can perform the following configurations for an aggregate interface:
z Configuring the Description of an Aggregate Interface
z Enabling LinkUp/LinkDown Trap Generation for an Aggregate Interface
z Shutting Down an Aggregate Interface
Configuring the Description of an Aggregate Interface
Follow these steps to configure the description of an aggregate interface:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter Layer 2 aggregate
interface view
interface bridge-aggregation
interface-number
—
Configure the description of
the aggregate interface
description text
Optional
By default, the description
of an interface is
interface-name Interface,
such as
Bridge-Aggregation1
Interface.
Enabling LinkUp/LinkDown Trap Generation for an Aggregate Interface
To enable an aggregate interface to generate linkUp/linkDown trap messages when the state of the
interface changes, you should enable linkUp/linkDown trap generation on the aggregate interface.
Follow these steps to enable linkUp/linkDown trap generation for an aggregate interface:
To do... Use the command... Remarks
Enter system view
system-view
—
To Next Page
Loading...
