H3C S5120-SI Series

1-15
To do… Use the command… Remarks
Enter cluster view
cluster
—
Configure the FTP server
shared by the cluster
ftp-server ip-address
[ user-name username
password { simple | cipher }
password ]
Required
By default, no FTP server is
configured for a cluster.
Configure the TFTP server
shared by the cluster
tftp-server ip-address
Required
By default, no TFTP server is
configured for a cluster.
Configure the log host shared
by the member devices in the
cluster
logging-host ip-address
Required
By default, no log host is
configured for a cluster.
Configure the SNMP NM host
shared by the cluster
snmp-host ip-address
[ community-string read
string1 write string2 ]
Required
By default, no SNMP host is
configured.
Configure the NM interface of
the management device
nm-interface vlan-interface
interface-name
Optional
To isolate management protocol packets of a cluster from packets outside the cluster, you are
recommended to configure to prohibit packets from the management VLAN from passing the ports that
connect the management device with the devices outside the cluster and configure the NM interface for
the management device.
Displaying and Maintaining Cluster Management
To do… Use the command… Remarks
Display NDP configuration
information
display ndp [ interface
interface-list ]
Display NTDP configuration
information
display ntdp
Display the device information
collected through NTDP
display ntdp device-list
[ verbose ]
Display the detailed NTDP
information of a specified
device
display ntdp single-device
mac-address mac-address
Display information of the
cluster to which the current
device belongs
display cluster
Display the standard topology
information
display cluster
base-topology [ mac-address
mac-address | member-id
member-number ]
Available in any view