To Next Page

To Previous Page

2-9

sftp-client> quit

Bye

Connection closed.

SFTP Server Configuration Example

Network requirements

As shown in Figure 2-2, an SSH connection is established between the host and the switch. The host,

an SFTP client, logs into the switch for file management and file transfer. An SSH user uses password

authentication with the username being client002 and the password being aabbcc. The username and

password are saved on the switch.

Figure 2-2 Network diagram for SFTP server configuration (on a switch)

Configuration procedure

1) Configure the SFTP server

# Generate RSA and DSA key pairs and enable the SSH server.

<Switch> system-view

[Switch] public-key local create rsa

[Switch] public-key local create dsa

[Switch] ssh server enable

# Enable the SFTP server.

[Switch] sftp server enable

# Configure an IP address for VLAN-interface 1, which the client will use as the destination for SSH

connection.

[Switch] interface vlan-interface 1

[Switch-Vlan-interface1] ip address 192.168.1.45 255.255.255.0

[Switch-Vlan-interface1] quit

# Set the authentication mode of the user interfaces to AAA.

[Switch] user-interface vty 0 4

[Switch-ui-vty0-4] authentication-mode scheme

# Enable the user interfaces to support SSH.

[Switch-ui-vty0-4] protocol inbound ssh

[Switch-ui-vty0-4] quit

# Configure a local user named client002 with the password being aabbcc and the service type being

SSH.

[Switch] local-user client002

[Switch-luser-client002] password simple aabbcc

[Switch-luser-client002] service-type ssh

H3C S5120-SI Series User Manual

Other manuals for H3C S5120-SI Series