11
3. Attach cage nuts (user supplied) to the front rack posts. Make sure the corresponding cage nuts
on the left and right rear rack posts are at the same height.
4. One person supports the chassis bottom with one hand, holds the front part of the chassis with
the other, and pushes the chassis into the rack gently. Make sure the shoulder screws rest
firmly on the upper edge of the rear mounting brackets. See Figure 13 and Figure 14.
5. The othe
r person attaches the front mounting brackets with M6 screws (user-supplied) to the
front rack posts. Make sure the switch is installed securely in the rack. See Figure 13 and Figure
14.
Figure
13 Mounting the switch in the rack (with the wide flange of the rear mounting brackets
inside the rack)
To Next Page
Loading...
Need help?
General