196
G CODES
96-8000
June 1999
G87 Bore and Stop and Manual Retract Canned Cycle Group 09
F Feed Rate in inches (mm) per minute
L Number of repeats
R Position of the R plane
X Optional X-axis motion command
Y Optional Y-axis motion command
Z Position of bottom of hole
This G code is modal in that once activated, every motion of X and/or Y will cause this canned cycle to be
executed until it is canceled or another canned cycle is selected. After manual jog press cycle start to resume
program.
To Next Page
Loading...
Need help?
General
