To Next Page

To Previous Page

300

PARAMETERS

June 1999

96-8000

HS3 SDMTCRSL This parameter bit is for the HS-3 sidemount tool changer. It must be

set to 1 on all HS-3 mills, and 0 on all other mills.

SAFETY INVERT This bit supports the CE door interlock that locks when power is

turned off. For machines that have the regular door lock that locks

when power is applied, this bit must be set to 0. For machines that

have the inverted door lock, this bit must be set to 1.

INV SPD DCEL Inverese Spindle Speed Deceleration. When this parameter is set to 1,

the spindle decelerates faster at lower speeds, resulting in a shorter

deceleration time.

SWAP A & C This parameter causes the A and C axes to be swapped internally.

This parameter bit should be set to 1 for the bridge mill. All other mills

should set this bit to 0.

INV SPD DCEL Inverse Spindle Speed Deceleration When this parameter is set to 1,

the spindle decelerates faster at lower speeds, resulting in shorter

deceleration time.

Parameter 279 X LSC GAIN MULTIPLIER

This parameter is used on machines with linear scales. Linear scales are used to

continuously correct any errors in the encoder position. The parameter determines the gain of

the correction factor, that is, how fast it corrects. This parameter should be set to 40.

Parameter 280 Y MAX 3rd DERIV

See parameter 279 for description

Parameter 281 Z MAX 3rd DERIV

See parameter 279 for description

Parameter 282 A MAX 3rd DERIV

See parameter 279 for description

Parameter 283 B MAX 3rd DERIV

See parameter 279 for description

Parameter 284 RESERVED

Parameter 285 X LSC OFFSET

This parameter is used on machines with linear scales. This parameters account for the

unused portion of the lead screw between zero and the actual motor. This parameters should

be a positive value (400000) unless the NEG COMP DIR bit for the axis is set, in which case

this parameter should be a negative value (-400000.)

Parameter 286 Y LSC OFFSET

See parameter 285 for description.

Parameter 287 Z LSC OFFSET

See parameter 285 for description.

Haas VF-1 User Manual

Questions and Answers: