EasyManuals Logo

Haas VF-1 User Manual

Haas VF-1
564 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #322 background imageLoading...
Page #322 background image
322
ALARMS
June 1999
96-8000
362 Tool Usage Alarm RESET. Tool life limit was reached. To continue, reset the usage count in
the Current Commands display and press
363 Coolant Locked Off Override is off and program tried to turn on coolant.
364 No Circ Interp Aux Axis Only rapid or feed is allowed with aux axes.
367 Cutter Comp Interference G01 cannot be done with tool size.
368 Groove Too Small Tool too big to enter cut.
369 Tool Too Big Use a smaller tool for cut.
370 Pocket Definition Error Check geometry for G150.
371 Invalid I, J, K, OR Q Check G150.
372 Tool Change In Canned Cycle Tool change not allowed while canned cycle is active.
373 Invalid Code in DNC A code found in a DNC program could not be interpreted
because of restrictions to DNC.
374 Missing XYZA in G31 or G36 G31 skip function requires an X, Y, Z, or A move.
375 Missing Z or H in G37 G37 automatic tool length measurement function requires H
code, Z value, and tool offset enabled. X, Y, and A values not
allowed.
376 No Cutter Comp In Skip SkipG31 and G37 functions cannot be used with cutter
compensation.
377 No Skip in Graph/Sim Graphics mode cannot simulate skip function.
378 Skip Signal Found Skip signal check code was included but skip was found when it
was notexpected.
379 Skip Signal Not Found Skip signal check code was included but skip was not found
when it was expected.
380 X, Y, A, or G49 Not Allowed in G37 G37 may only specify Z-axis and must have tool offset defined.
381 G43 or G44 Not Allowed in G36 or G136 Auto work offset probing must be done without tool offset.
382 D Code Required in G35 A Dnn code is required in G35 in order to store the measured tool
diameter.
383 Inch Is Not Selected G20 was specified but settings have selected metric input.
384 Metric Is Not Selected G21 was specified but settings have selected inches.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Haas VF-1 and is the answer not in the manual?

Haas VF-1 Specifications

General IconGeneral
BrandHaas
ModelVF-1
CategoryPower Tool
LanguageEnglish

Related product manuals