323
ALARMS
June 1999
96-8000
385 Invalid L, P, or R G10 was used to changes offsets but L, P, or R code is missing
or Code In G10 invalid.
386 Invalid Address Format An address A...Z was used improperly.
387 Cutter Comp Not Allowed With G103 If block buffering has been limited, Cutter comp cannot be used.
388 Cutter Comp Not Allowed With G10 Coordinates cannot be altered while cutter comp is active.
Move G10 outside of cutter comp enablement.
389 G17, G18, G19 Illegal in G68 Planes of rotation cannot be changed while rotation is enabled.
390 No Spindle Speed S code has not been encountered. Add an S code.
391 Feature Disabled An attempt was made to use a control feature not enabled by a
parameter bit. Set the parameter bit to 1.
392 B Axis Disabled Same as alarm 336.
393 Invalid Motion In G74 or G84 Rigid Tapping can only be in the Z minus G74 or G84 direction.
Make sure that the distance from the initial position to the
commanded Z depth is in the minus direction.
394 B Over Travel Range Same as alarm 316.
395 No G107 Rotary Axis A rotary axis must be specified in order to perform cylindrical
mapping Specified (G107).
396 Invalid G107 Rotary Axis Specified The rotary axis specified is not a valid axis, or has been disabled.
397 Aux Axis In G93 Block This alarm is generated if a G-code block specifies any form of
interpolated motion that involves BOTH one or more of the
regular axes (X, Y, Z, A, B, etc...) AND one or more of the auxiliary
axes (C, U, V, W).
398 Aux Axis Servo Off Aux. axis servo shut off due to a fault.
403 RS-232 Too Many Progs Cannot have more than 200 programs in memory.
404 RS-232 No Program Name Need name in programs when receiving ALL; otherwise has no
way to store them.
405 RS-232 Illegal Prog Name Check files being loaded. Program name must be Onnnn and
must be at beginning of a block.
406 RS-232 Missing Code A receive found bad data. Check your program. The program will
bestored but the bad data is turned into a comment.
407 RS-232 Invalid Code Check your program. The program will be stored but the bad
data is turned into a comment.
To Next Page
Loading...
Need help?
General
