Haemonetics Cell Saver 5+ - Page 110

P/N 53063-30, Manual revision: B
7-4
Sequestering using the Cell Saver 5+ System
The following information will be displayed and the operator should
proceed as follows:
Figure 7-2, Example of the Cell Saver setup menu
" Press the Select key until Protocol is highlighted.
" Press the#Arrow keys [!"] to change the selection to Sequester.
" Press the Modify key to return to the STANDBY state screen.
The screen display will now indicate Sequester on the right side as follows:
Figure 7-3, Example of the STANDBY state screen display (Sequester)
EHDIJED:+ J/0#O(8*#T,-?5&P !MMM#5-
2&8&%T,/%#-&T&-P LMM#5-
2&8?5&#()#-&T&-P ;MM#5-
$?5'#2Q+8#),P Q-?&#G/0&
NI#OEA<#,')/,0P ICC
G&T&-#8&08,%P IN
E?),+4.-&P ICC
A'&&3#%&=?-()/,0P IN
$%,),.,-P +&--#A(T&%
$%&88#E22IO#Z&48#),#.*(0=&#T(-?&8"
$%&88#AFGF+D#),#(3T(0.&#*/=*-/=*)"
$%&88#JIR:CS#7*&0#V/0/8*&3"
+&--#A(T&%#AFDH$
A&a?&8)&% K,-?5&8#5-
$2I+ M
2F:NC M
Q,7-8#'%,.&88&3P M
$%&88#ADE2D#),#V/--#6,7-"
$%&88#JIR:CS#),#.*(0=&#'(%(5&)&%8"
$%&88#SFA#),#8&-&.)#+&--#A(T&%#'%,),.,-"
ADENRQS