P/N 53063-30, Manual revision: B
4-7
Preparing for a Cell Saver 5+ Procedure
Explaining the bowl type confirmation message
Once the disposable set has been loaded on the CS5+ device, the system
will automatically detect the size of the bowl and adjust the processing
parameters accordingly.
If for any reason the system cannot detect the type of bowl which has been
installed, the following message will be displayed:
Figure 4-5, Bowl type confirmation message
If this message should appear, the operator should:
" Press the Select key to select and highlight the correct bowl type.
" Press the Start key to confirm the selection.
Once the type of disposable bowl in use has been confirmed for the CS5+
system, the message will not appear again. This message could be displayed
during the procedure up to and including the first fill cycle.
$-&(8&#.,0V/%5#)*,7-"
!XQJQ#BM#5-#6,7-"
1XG()*(5#6,7-#!1>#5-#,%#11>#5-"
D,#8&-&.)#(#6,7-#)4'&`#'%&88#AFGF+D"
D,#.,0V/%5#)*&-&.)/,0`#'%&88#ADE2D"
QIOG#DS$F#+<I:+F NID:+F
To Next Page
Loading...
