Hakko Electronics Monitouch V9 Series Troubleshooting Instructions Supplement

2
2. Local Mode Screen 2-23
Local Mode Screen
Restoring Settings in the Screen Program
This section explains how to restore the screen program settings after the communication settings
were changed on the V9 series unit.
1. Press [Comm. Setting] in the menu icons. The Communication Setting screen is displayed.
2. To restore a specific communication parameter for PLCX, press [<<] and [>>] switches to select
the connected device targeted for restoration.
3. Press the [Restore Screen Program Settings] switch. The following dialog box appears.
To restore the screen program settings for only the currently displayed PLCx, press the [Reset
PLCx Only] switch. To restore for all PLCs 1 to 8, press the [Reset All] switch.
* When restored, changes made on the V9 series unit are cancelled.
4. Communication settings are refreshed and the [System Information] screen is displayed.

Hakko Electronics Monitouch V9 Series Specifications

General

Brand	Hakko Electronics
Model	Monitouch V9 Series
Category	Monitor
Language	English