Service instructions | 73Trophy Service instructions | 73Service instructions | 73
8. Miles / hour reset (P)
Set speed and distance calculations to km or miles.
• Km icon on display is shown = km: km per hour
• m icon on display is shown = miles: miles per hour
Default: km
Change by pressing the DSS (I) switch ≥ 2 seconds.
9. Scooter type selection.
This refl ects the diameter of the wheels used.
• “t30” Trophy speed algorithm (Trophy 30)
• “t20” Trophy speed algorithm (Trophy 20)
Default: “t30”
Change by pressing the DSS (I) switch ≥ 2 seconds.
10. This refl ects if a beeping sound is enabled
• "0" no beep when driving backward
• "1" beeping when driving backward
default: "1"
Change by pressing the DSS (I) switch ≥ 2 seconds
First one character of the display show: b
Setting the options
Not all options are standard available. Some options are only available as ordered at Handicare. Not activated values will not be
shown in the service menu.
11. Cruise Control enable (S)
• “0” disabled
• “1” enabled
Default: “0” = disabled
Change by pressing the DSS (I) switch ≥ 2 seconds.
First two characters of the display show: CC
12. Manual / intelligent throttle switch
• “0” off
• “1” Manual Throttle Switching (MTS)
• “2” Intelligent Throttle Switching (ITS)
• “3” ITS and MTS active
Default: “0” = off
Change by pressing the DSS (I) switch ≥ 2 seconds.
First two characters of the display show: tS
To Next Page
Loading...
