Hantek DSO8000E Series - Autoset; Fast Action Buttons

Basic Operation
DSO8000E Series HandHeld Oscilloscope User Manual 47
Fast Action Buttons
5.6
AUTORANGE: Automatically set the oscilloscope controls to generate a usable display of the
input signals in real time.
AUTOSET: Automatically set the oscilloscope controls to generate a usable display of the input
signals. Refer to the following table for relative content.
RUN/STOP: Continuously acquire waveforms or stop the acquisition.
5.6.1 AUTOSET
Autoset is one of the advantages digital oscilloscopes have. When you push the AUTO button, the
oscilloscope will identify the type of waveform (sine or square wave) and adjust controls according
to input signals so that it can accurately display the waveform of the input signal.
Functions
Settings
Acquire Mode
Adjusted to Normal or Peak Detect
Cursor
Off
Display Format
Set to YT
Display Type
Set to Vectors for an FFT spectrum; otherwise, unchanged
Horizontal Position
Adjusted
TIME/DIV
Adjusted
Trigger Coupling
Adjusted to DC, Noise Reject or HF Reject
Trigger Holdoff
Minimum
Trigger Level
Set to 50%
Trigger Mode
Auto
Trigger Source
Adjusted
Trigger Slope
Adjusted
Trigger Type
Edge
Trigger Video Sync
Adjusted
Trigger Video Standard
Adjusted
Vertical Bandwidth
Full
Vertical Coupling
DC (if GND was chosen before); AC for the video signal; otherwise,
unchanged
VOLTS
Adjusted
The Autoset function examines all channels for signals and displays corresponding waveforms.
Autoset determines the trigger source according to the following conditions.
 If multiply channels get signals, the oscilloscope will use the channel with the lowest