Hantek DSO8000E Series User Manual

Basic Operation
DSO8000E Series HandHeld Oscilloscope User Manual 48
frequency signal as the trigger source.
 If no signals are found, the oscilloscope will use the lowest-numbered channel displayed
in Autoset as the trigger source.
 If no signals are found and no channels are displayed, the oscilloscope will display and
use Channel 1 as the trigger source.
Sine Wave:
When you use the Autoset function and the oscilloscope determines that the signal is similar to a
sine wave, the oscilloscope displays the following options.
Sine Wave Options
Details
Multi-cycle Sine
Display multiple cycles that have appropriate vertical and
horizontal scales.
Single-cycle Sine
Set the horizontal scale to display about one cycle of the
waveform.
Cancel
Let the oscilloscope recall the previous setup.
Square Wave or Pulse:
When you use the Autoset function and the oscilloscope determines that the signal is similar to a
square wave or pulse, the oscilloscope displays the following options.
Square Wave Options
Details
Multi-cycle
Display multiple cycles that have appropriate vertical and
horizontal scales.
Single-cycle
Set the horizontal scale to display about one cycle of the
waveform. The oscilloscope displays Min, Mean and Positive
Width automatic measurements.
Rising
Display the rising edge.
Falling
Display the falling edge.
Cancel
Let the oscilloscope recall the previous setup.
Signal Connectors 5.7
See the figure below to find the four signals connectors and a pair of metal electrodes at the
bottom of the oscilloscope panel.
CH1
OUTPUT
EXT TRIG/SYNC
CH2

Hantek DSO8000E Series Specifications

General

Brand	Hantek
Model	DSO8000E Series
Category	Test Equipment
Language	English