Hantek DSO8000E Series - Chapter 9 Waveform Generator; Waveform Generator

Waveform Generator
DSO8000E Series HandHeld Oscilloscope User Manual 83
Chapter 9 Waveform Generator
DSO8000E Series oscilloscope is equipped with waveform generator function, with one channel of
arbitrary waveform output, 8 Bits output, synchronized signal out puts. User can edit the waveform
by the mouse or choose the regular waveforms such as Sine, Ramp, Square, Trapezia, DC,
Exponent, AM/FM.
Waveform Generator 9.1
Waveform Parameter Setup
Select a wave type, and you can set the “Parameters” by the near key.
Generate the Sine waveform
To output a Sine Wave, please do the following steps:
1. Press F1 button to select "Sine".
2. Set the Wave Parameter:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Offset: Set the output wave vertical level offset.
Generate the Ramp waveform
To output a Ramp Wave, please do the following steps:
1. Press F1 button to select "Ramp".
2. Set the Wave Parameter:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Offset: Set the output wave vertical level offset.
Duty: The duty of the output wave.
Generate the Square waveform
To output a Square Wave, please do the following Step:
1. Press F1 button to select "Square".
2. Set the Wave Parameter:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Offset: Set the output wave vertical level offset.