Hantek DSO8000E Series User Manual

Waveform Generator
DSO8000E Series HandHeld Oscilloscope User Manual 84
Duty: The duty of the output wave.
Generate the Trapezia waveform
To output a Trapezia wave, please do the following steps:
1. Press F2 button to select "Trap".
2. Set the Wave Parameter:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Offset: Set the output wave vertical level offset.
Duty: The duty of the output wave.
Rise Duty: Set the output wave rise duty.
High Duty: Set the output wave high duty.
Fall Duty: Set the output wave fall duty.
Generate the Exponent waveform
To output an Exponent Waveform, please do the following steps:
1. Press F1 button to select the wave "Exp".
2. Set the Wave Parameters:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Offset: Set the output wave vertical level offset.
Phase: Set the output wave phase.
Time: Set the ouput wave Tao param.
Exp Type: Set the output wave slope.
Generate the AM/FM waveform
To output an AM/FM Wave, please do the following Steps:
1. Press F1 button to select "AM/FM Wave".
2. Set the Wave Parameter:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Offset: Set the output wave vertical level offset.
Depth: Set the output wave Depth.
Type: Change the output wave "AM" into "FM"
Max Freq: Set the output wave Max Frequency.
FM: Change the output wave "AM" into "FM".

Hantek DSO8000E Series Specifications

General

Brand	Hantek
Model	DSO8000E Series
Category	Test Equipment
Language	English