Multimeter
DSO8000E Series HandHeld Oscilloscope User Manual 69
Figure 7-3 Diode Measurement
Making an On-off Measurement
To perform an On-off test, do the following:
1) Press the F1 key to select CON and then On-off indictor appears on the top of the screen.
2) Insert the black lead into the COM banana jack input and the red lead into the V/O/C banana jack
input.
3) Connect the red and black leads to the tested points. If the resistance value of the tested points
is less than 30 Ω, you will hear beep sound from the test tool.
Then, the screen will look like the following figure 7-4.
Figure 7-4 On-off Measurement
To Next Page
Loading...
Need help?
General
