Hardi 5500

18
HARDI CONTROLLER 5500
Menu 2.2 Auto functions
Menu [2.2.1 ON/OFF]Menu [2.2.1 ON/OFF]
Menu [2.2.1 ON/OFF]Menu [2.2.1 ON/OFF]
Menu [2.2.1 ON/OFF]
The Controller can be set to open the main ON/OFF function above a
certain speed and close it below the same speed. This allows the user to
concentrate on driving. If the speed is set at zero the function is deactivated.
Suggested speed setting is spraying speed less 20%.
When the Auto ON/OFF is active and the main switch and boom section
switches are on, the boom status symbol on the 1
st
line will blink when
speed is under the trigger value.
WARNING: Remember to set the main ON/OFF switch to OFF before
leaving the field, otherwise the main ON/OFF will open under transport.
Menu [2.2.2 Foam marker]Menu [2.2.2 Foam marker]
Menu [2.2.2 Foam marker]Menu [2.2.2 Foam marker]
Menu [2.2.2 Foam marker]
The Controller can be set to operate the HARDI Foam marker automatically
through the main ON/OFF valve. When the main ON/OFF is ON, it will
automatically start the Foam marker.
Furthermore, the Foam marker can be set for up and back spraying or race-
track (round and round) spraying.
Setting Activity
[Disable] The marker will only follow the setting of the switch on the
Spray Box.
[Same side] The Controller will automatically activate the same side for
race-track spraying.
[Change side] The Controller will automatically change side for up and
back spraying.
Foam marker status is shown on the line 4 of the screen every 5 seconds.
Menu 2.3 Variable Rate Application (VRA) / Remote
If the volume rate is to come from an external source (e.g. a site specific
application map or a remote sensor), this menu has to be enabled.
NOTE: If using UCR for mistblowers:
• Readout is only possible on the 4th line.
• Readout changes as listed below.
[2.1.1 Program: Actual] Programmed and corrected rate
[2.1.5 Work rate] Rate shown in metres per hour
[2.1.6 Volume rate] Actual rate in Litres per UCR
[2.1.9 Volume: Area] 2 readouts on the same line