19
HARDI CONTROLLER 5500
2.5.6
AUDIO LEVEL
Sound step X
Activated at XX %
2.5.1
ALARMS
Volume rate
Menu 2.5 Alarms
Six different alarms can be set up. Choices are listed as follows.
Display text Notes
[2.5.1 Volume rate] Suggested setting is 10%
[2.5.2 Tank contents] Measured in Litres
[2.5.3 Optional sensor X] High/low pressure
[2.5.4 Optional sensor Y] High/low rpm
[2.5.5 Speed] Speed max./min.
[2.5.6 Audio level] 0 = no sound, 5 is max. volume
[2.5.7 Sections off] Sections switched to OFF
When outside the alarm parameters, the relevant warning will flash. The
alarm beep can also be adjusted in audio level in menu [2.5.6 Audio level].
Volume rate alarm for over or under application
for more than 20 seconds.
Suggested setting is 10%. For no alarm, set at 0.
The symbol on the 1
st
line is now visible. Manual pressure regulation
and stepped over/under application is still possible.
The external source is connected to the COM 1 or COM 2 via a 9 pin sub D
connector.
Menu 2.4 Set clock
See page 10.
To Next Page
Loading...
