Hardi 5500

13
HARDI CONTROLLER 5500
1.1
VOLUME RATE
XXXX L/ha
Menu 1.1 Volume rate
The volume rate can be changed by:
1. Setting the desired rate in the Controller.
2. Manually raising or lowering the pressure via the Spray Box.
3. Pressing or to apply over or under in a preset percentage,
e.g. 10% (the 3rd line indicates when this is active)
or
4. Pressing or to change to one of 3 preset volume rates.
Items 3 or 4 are only possible for broad-acre spraying.
To read the Volume rate:
Shortcut .
Press and hold until menu [1.1 VOLUME RATE] is shown.
To change volume rate:
Move cursor with or to the value to be changed.
Use or to change the value.
Press to confirm.
Press and hold to exit the menu system.
If the volume rate is set up with 3 programmable rates, there are three
possibilities to enter volume rate.
[1.1.1 Rate 1] (Default)
[1.1.2 Rate 2]
[1.1.3 Rate 3]
NOTE: Normally, under 0.5 km/h, the Controller will not regulate automatically.
Manual dosageManual dosage
Manual dosageManual dosage
Manual dosage
To dose in manual mode, use the pressure switch on the Spray Box. The
manual mode is indicated by the symbol at the top of the display.
To go from manual to preset volume rate, press .