Hardi 5500 - Stopwatch Function; Alarm Clock Function; Transducer Test Function; Speed Simulation Function

33
HARDI CONTROLLER 5500
4.5.1
TEST
Flow
Menu [4.5 Test]
All readouts for the transducers are in accumulated counts, i.e. one signal
gives one count, except for the optional (analog) transducer that is read in
milli-ampere.
Go to menu [4.5 Test]. Choose the item to be tested and open the menu.
Activate sensor and see if the signal is detected.
[4.5.1 Flow]. Enter this menu to test the flow sensor.
[4.5.2 Speed].
[4.5.3 Optional sensor].
[4.5.4 Active switches].
Menu [4.6 Speed simulation]
Speed may be simulated for certain purposes. A two figure value may be
entered.
The state remains valid until the Controller is re-starting or the value is set
to “0”.
Menu [4.3 Stop watch]
The clock can be used as a timer.
Press to start and stop.
Use to clear the value.
Menu [4.4 Alarm clock]
The clock can be set to give an alarm when the time is reached.
Press . Use navigation keys to set alarm.