4 - Sprayer Setup
87
The restrictors inside the hydraulic block have different orifices depending on the oil flow returned to the tractor’s oil pump.
A. Orifice is ø0.8 mm (default setting).
B. Orifice is ø1.2 mm
C. Orifice is ø1.6 mm
• Check the hydraulic flow by activating a hydraulic lever in the
tractor. If the reaction time for the hydraulic function is relatively
short, continue your work with this restrictor installed.
• If the reaction time seems too long before the hydraulic function is
enabled, switch the plug (E) in port (A) with the plug (F) in port (B)
to allow more oil flow to pass through.
• If the reaction time is still too long, switch the plug (E) in port (B)
with the plug (F) in port (C).
• Always mount the plug (E) in the port used, and mount the other
plugs (F) in the ports not used.
• Ask your HARDI dealer for correct setup if in doubt.
Combinations of settings for hydraulic block:
*If the tractor requires pressure relief, contact your tractor dealer for further advice.
±
WARNING! It is essential that connectors on the sensing line are kept totally clean, so that impurities do not enter the
pump. Impurities may cause damage to vital pump parts.
Before operating the hydraulics, the valve should be set according to the specific tractor model. If you are unsure of
the type of hydraulic system in your tractor, please contact your tractor dealer.
÷
NOTE! A spare part kit for connecting the hydraulic block to the tractor - ask for HARDI item no. 74193800.
Application Valve 1 Valve 2 Port A, B or C
Open centre Out Out No change
Closed centre In In No change
Load sensing (LS) In Out* Change if needed
To Next Page
Loading...
