12. Using the screws in the pendant rear cover, attach the shipping bracket to the back of the
control pendant. Refer to Figure 2.45.
13. Swing the pendant into position and secure to the top of the machine guard using the fasteners
present in the guard. Refer to Figure 2.46.
14. Verify the main guard door is completely closed.
15. On T-51 and T-65 lathes, install guard door shipping bracket "Y", Figure 2.47.
2-32 M-507C
Figure 2.45 - Shipping Bracket
Attached to Control Pendant
TP7957
Figure 2.46 - Control Pendant
Secured in Position
TP7955A
Figure 2.47 - Guard Door Shipping Bracket
(T-51 and T-65 Lathes)
TP8319
Y
To Next Page
Loading...
