HI 6600 Series Modular Sensor System User Guide
Page | 48
Chapter 5
Instrument Operation
• • • • • •
Operations
The following parameters are used for instrument operations:
Tare Operations
o Tare Amount
o Tare Offset
o Tare
Zero Operations
o Zero Tolerance
o Zero Amount
o Zero
Auto Mode
o Auto Mode Enabled
o Auto Mode Disabled
Count Operations
o Count Enable
o Unit Weight
o Sample Size
o Weigh Sample
Tare Parameters and Commands
Tare Amount
The Tare Amount parameter displays the total amount that has been "Tared" from the scale
minus the Tare Offset.
This value is reset to zero when net and gross are the same weight, and totalizes the
differences each time the Tare
command is run. This value excludes the initial Tare Offset
value, which is a constant value subtracted from the Net
weight value without the operator
running the Tare command
From the Web page or Using the Front Panel Display: Enter the Tare Amount in the text box provided or use the arrow
keys to enter the Tare amount.
To Next Page
Loading...