Hardy Process Solutions HI 6600-EIP - Security Features; Optional HI 6110 Display Security Options

HI 6600 Series Modular Sensor System User Guide
Page | 79
Chapter 7
Security
• • • • • •
Chapter 7 covers the security menu, which allows the user to lock out different levels of the menu hierarchy.
The user configurable security settings only limit access through the Optional Front Panel to ensure the
consistency of the instrument setup and weighing process. Parameter configuration through the network is
unaffected by these security settings.
Note: Security settings are universal and are applied to all channels on the system. For example, if
Calibration Security is selected, then a password is required to calibrate ANY Weight Processor
Module on the System.
Optional HI 6110 Display Security Options
Lock Enabled Operation
Dis
p
la
y
Dis
p
la
y
is
b
lank
;
an
d
the Mode
,
Tare
,
Zero
,
an
d
Confi
g
uration
b
uttons are disabled. Pressing ENTER jumps to the
p
asswor
d
p
rompt.
Keypad Display is active; and the Mode, Tare, Zero, and Configuration
b
uttons are disabled. Pressing ENTER jumps to the
p
asswor
d
p
rompt.
Configuration Display is active, and the Mode, Tare, and Zero buttons are active;
b
u
t
the configuration
b
utton is disabled. Pressing CONFIG jumps
to the configuration
p
asswor
d
p
rompt.
Read Only
Display is active, and the Mode, Tare, and Zero buttons are active,
the configuration
b
utton is active
b
u
t
no
p
arameters can
b
e
modified.
Calibration Display is active, all buttons are active, and all the parameters
excep
t
the calibration
p
arameters can
b
e modified.
N
o Locks Enable
d
When no locks are selected, the display is active, all buttons are
active, an
d
all the
p
arameters can
b
e modified.
The current status and password for each level of security can be read and changed through the web browser
if using an Ethernet connection, or through the serial interface.
To access or modify the security parameters through the Optional Front Panel display, a password always
needs to be entered before a lock can be enabled or disabled or the password modified. Note, that as the
password can be read over the network, any security password can always be over written if the local
operator enters an incorrect password.