VPL400-X: Install Manual
21JULY2023 | 630-00159 B
25
INSTALLATION
VPL400-X: SECTION 4
OPERATIONAL CHECK
Upon installation and at scheduled intervals the
operation of the VPL must be verified.
Apply power.
Paddle/buttons on cab controls control UP
and DOWN travel.
E-Stop PRESSED IN stops and prevents travel
of platform. Button illuminates and alarm
sounds (if equipped).
Key switch (if equipped) OFF stops and
prevents travel.
Landing switches stop the platform at each
opens the gate locks.
Open doors/gates prevent any travel of the
platform. If not, check the platform gate
cable is plugged into the trailing cable and
the red wire is cut/removed on the Lower
Landing Jumper Connector.
travel.
Key switch (if equipped) OFF on Call Stations
stops and prevents travel from Call Station.
Safety pan switches depressed prevent
DOWN travel and allows UP travel (check
several locations).
Pit switch (if equipped) prevents UP and
DOWN travel.
To Next Page
Loading...
