VPL400-X: Install Manual
21JULY2023 | 630-00159 B
5
INTRODUCTION
VPL400-X: SECTION 2
SECTION 2
INTRODUCTION
DEVICE NAME: HARMAR
VPL400-X
Indications of Use:
The Harmar Highlander 400-X Vertical Platform
Lift is to aid in the safe and efficient transfer of
individuals with limited mobility or disabilities, along
with their mobility devices, between different levels
of a residential building.
READ AND UNDERSTAND
This manual provides instructions for the proper
installation and service of the Harmar VPL400-X
Vertical Platform Lift which is critical to the lift’s
safety, performance and durability. Please refer
to the Owner’s Manual for operating instructions.
Any alterations to the equipment without written
authorization by the manufacturer is prohibited and
will void the warranty.
TECHNICAL SPECIFICATIONS
Visit harmar.com for specifications on the particular
lift model and configuration.
CODE STATEMENT
The Harmar VPL400-X lift has been designed to
meet Safety standard ASME A18.1-2020 “Safety
Standard for Platform Lifts and Stairway Chairlifts”
under section 5 and has been certified to CSA B44.1/
ASME A17.5-2019 “Elevator and Escalator Electrical
Equipment”.
Code requirements for Vertical Platform lifts may
vary depending on location. It is the installers
responsibility to contact their state, city or local
code enforcement office and determine all the
regulations the lift and installation are subject
to. You must do this before installing the Vertical
Platform Lift.
APPLICABLE STANDARDS
BASED ON INSTALLATION
TYPE
Residential installations require compliance to the
Safety standard ASME A18.1-2020 safety code and
other codes that may be adopted by state, city and
local code authority having jurisdiction.
To meet the full intent of Safety standard ASME
A18.1-2020 regulation the installer is required to
contact their state, city or local code authority
having jurisdiction for permits, adopted rules and
inspections of the vertical platform lift.
To Next Page
Loading...
